set of M10 head studs (replacement for serial bolts)

use of pins in M52 M54 engines (only aluminum blocks).

The stud set is a very important element for any conversion on M52 and M54 aluminum engines.

A stud, NOT a SCREW -> less risk of tearing out the thread in the block as is the case with standard bolts.

*Attention! We suggest using our M12 or ARP pins for TURBO SETUP !

*We do not accept a guarantee in the event of thread breakage, or the pin being stretched by too much tightening power.

To our kit we add arp grease and suggested tightening torque.

klass 12,9+

*WE DO NOT RECOMMEND USE FOR SUPERCHARGED/TURBO ENGINES.

WE SUGGEST USE AS A REPLACEMENT FOR SCREWS, n/a setup which may cause the THREAD to be pulled out during installation.